Job Description

1. Responsible for all Engineering correspondence (ME issues) between customer and company, and carry out necessary co-ordination with internal departments. 
2. To establish and maintain the product assembly BOM (Bill of Material) to meet the products specification.
3. To ensure critical areas required for inspection are listed in the Quality inspection guideline.
4. Responsible for all Engineering correspondence (ME issues) between customer and Venture, and carry out necessary co-ordination with internal departments. 
5. To perform failure mode analysis. (FMEA / PFMEA)
6. To carry out and support production line and product system test. 
7. To plan and implement problem free production process to meet the quality and plan output target.
8. To implement production control to ensure quality products are produced on time for delivery.
9. To participate in the statistical process control and quality improvement program.
10. To plan and coordinate on all fixtures fabrications, equipment requirements and qualify new process flow.
11. To review the process standard time and drive improve output and timing.
12. To monitor on the production reject or scraps and reduce the line defects.
13. To plan, run and qualify the new product run.
14. To implement rework methods and monitor on all rework due to Engineer Change Order (ECO).
15. To ensure all workers under his/her supervision have obtained necessary training. 
16. The qualification of fixtures fabricated and its use on the production line, the process flow and output achieve.
17. The approval of rework methods in compliance to IPC and/or customer standards change of the process/machine parameters.
18. To follow company policies and procedures.